Why Is My SWR So High?

Can high SWR damage a radio?

High SWR can reflect enough power back into the radio to create enough heat to cook the final RF transistor.

It isn’t usually an immediate failure, it takes some time for that heat to build up and do damage..

What should the SWR be on a CB?

By adjusting and setting the “SWR” on the entire bandwidth (high and low channels), it will ensure optimum performance on all of your radio channels. The radio will receive and transmit with a “SWR” reading of 2.5 or less across all channels, however, the lower the “SWR” reading the better your radio will perform.

Does coax length affect SWR?

Many antennas have a SWR of just over a perfect match like a SWR of 1 to 1.2. This is measured at the antenna itself. With a length of coax the SWR will now show a SWR of say 1 to 1.0 , because of the loss in the coax. And so will the bandwidth change a little.

What causes high SWR reading?

One of the most common causes of high SWR readings is incorrectly connecting your SWR meter to your radio and antenna. When attached incorrectly, readings will be reported as being extremely high even if everything is installed perfectly.

What does a very high SWR reading mean?

What does a very high SWR reading mean? The transmitter is putting out more power than normal, showing that it is about to go bad. The antenna is the wrong length, or there may be an open or shorted connection somewhere in the feed line. There is a large amount of solar radiation, which means very poor radio conditions.

What does an SWR reading of 4 1 indicate?

What does an SWR reading of 4:1 indicate? Loss of -4 dB. Good impedance match. Gain of +4 dB. Impedance mismatch.

What SWR is too high?

SWR Range Explanations. SWR 1.0-1.5: The ideal range! If your SWR is under 1.5, you’re in great shape. If you’re at 1.5 and really, really want to drop down to closer to 1 it’s likely possible to do with addition tuning, different equipment or a different mounting location.

What is a good SWR?

SWR 1.0-1.5: The ideal range! If your SWR is under 1.5, you’re in great shape. … SWR 1.5 – 1.9: There’s room for improvement, but SWR in this range should still provide adequate performance. Occasionally, due to installations or vehicle variables, it’s impossible to get SWR lower than than this.

Can high SWR damage a radio?

High SWR can reflect enough power back into the radio to create enough heat to cook the final RF transistor. It isn’t usually an immediate failure, it takes some time for that heat to build up and do damage.

What is acceptable SWR?

What is a good SWR reading ? The best reading possible is 1.01:1 (46dB return loss), but usually a reading below 1.5:1 is acceptable. Outside the perfect world a 1.2:1 (20.8dB return loss) is spot on in most cases. To ensure an accurate reading, it is best to connect the meter at the base of the antenna.

How do I adjust the SWR on my antenna?

Turn the radio to channel 1. Key the microphone (depress the button and hold it). Turn the knob on the SWR meter labeled “SET” or “ADJUST” until the needle reaches the setting position at the end of its range. While still keying the microphone, flip the switch on the SWR meter to the “REF” or “SWR” position.